This change controls a GPIO on the expansion connector depending on the
surrounding temperature. If external temperature is too low for
charging, the GPIO is set high, else it is set low.
In combination with the new LNSC-2420-Addon board this allows to switch
on a high-power heater connected directly to the solar panels whenever
the temperature is too low to charge the battery. Once the temperature
becomes high enough again, the heater is switched off and the battery is
charged instead.
This version uses only blocking i2c calls, and long transfers will
probably cause frame loss. Also, if no BMP280 is present, the firmware
will not start up and hang in an endless loop instead.
Thomas Kolb
Thomas Kolb